Humax Error Page
During upload to your STB's some error messages may appear on the Humax LEDs display.
Refer to the chart below for identifying the problem, and find a possible remedy... Good luck !!!
|
Error |
Meaning |
Possible Remedy |
|
E-HC/bC
|
Incorrect header block (CRC-16)
|
The software seems damaged while you receive from web site or e-mail. Download software again and send to STB one more time. |
|
E-dC
|
Incorrect data block (CRC-16)
|
The software seems damaged while you receive from web site or e-mail. Download software again and send to STB one more time. |
|
E-Hn/bF
|
Invalid HDF version
|
This error can be ocured when you attempt to download Non-Superset STB software to Superset or Vice-Versa .Pls check the STB model and the software |
|
E-Id
|
Invalid system ID
|
This error can be ocured when you attempt to download F1 software to F1-CI. Pls check the STB model and the software |
|
E-AC
|
Incorrect application CRC-32
|
Download latest version of application sw. If it doesn't make it ,the flash memory can be thought to be defected |
|
E-ut
|
UART RX/TX time out
|
There is communication problem between source and target 1) Check whether the S/W is compressed or not and Check whether you use the proper download tool for the software 2) Reduce the download speed and try to download again 3) STB main power Off/On and try to download again 4) Reset the PC and try to download again |
|
E-Ad
|
Invalid address
|
Humax made the hdf file with wrong address .Wait for a new release with the proper software. |
|
E-Ao
|
Invalid offset address for upload (Odd offset) |
There was a mistake when we made hdf file from binary file. Wait for a new release version |
|
E-Ft
|
Flash program time out
|
The flash memory in STB seems damaged. Try to download one more time. If you fail again ,replace the flash memory device |
|
E-It/Et
|
EEPROM program time out
|
The EEPROM in STB seems damaged .Pls try to download one more time. If you fail again ,replace the EEPROM device |
|
E-FE |
Fail compare after flash write |
Flash memory is damaged.Return the main board(CPU Board) |
|
E-HF
|
Invalid HDF Format
|
It means that the file you try to download is not a valid HDF format. The file could be damaged in which case you should try downloading it from the Humax web site again. Also please check the file extension is HDF. Also make sure you are using the correct download tool - Wdn4oak+. It can be also occurred when there is some problem on cable, data of PC and loader. |
|
E-Fn |
Invalid flash device
|
Flash memory is defected. Need to change the flash memory Return the Main Board |
|
E-AS |
Incorrect application size |
Check the software version and STB hardware specification |
ON SCREEN CODES
(
The usual "service not running or scrambled" )
0100 (Seca)
0500 (Viaccess)
0602 (Irdeto
)0604 (Irdeto 2)
1702 (Betacrypt)
1722 (Betacrypt)
1762 (Betacrypt)
1800 (Nagravision)